Jump to content

opsirc

we are 'the leading edge' I Share on HSO
  • Posts

    750
  • Joined

  • Last visited

Everything posted by opsirc

  1. I am posting these for my son, so you will need to use the contact info listed at the bottom. Clam Yukon TC includes: 2 hooks Sportsman caddy Extra pole clips Extra slide release clips Rear cargo net Sled lights Travel cover 400 for kit 2 year old Strikemaster 8 inch magnum chipper. Used handful of times 137 solo motor. Includes: carry bag Strikemaster oil kits. 275.00 it may take him a little while to answer as he can not always respond quickly when he is at work. you can call or text 218.750.7826
  2. what do most used? a battery hooked to a charger or a converter to power them?
  3. bought the one with reverse, paid $450 for it, hard to pass up.
  4. I decieded to go with the Ion. did not want to have to worry about mixing or hauling gas. Not to mention trying to get rid of the gas odor off hands while fishing after filling tank.
  5. The new ion seems to be the rage right now, but wanted to get thoughts on the ION versus the strikemaster battery. The strikemaster is a bit cheaper, but does not have reverse. both were well rated.
  6. I have a strikemaster lazer mag that is a few years old. it has the 2 hp Tecumseh motor, usually starts with a few pulls. this years when i tried to start for the first time, the only way I can keep it running is with 3/4 to full choke, when I tried to throttle it, it dies. I put in new gas mixed 100:1 using am-soil saber, and a new plug. took the carb off and it seems to be working properly. I am out of ideas. anyone have different ideas? thanks
  7. what do u use to attached our reels to rods that do not have the rings all ready on them?
  8. does anyone have a photo of a drop down axle without the tires on that they would be willing to share. thanks
  9. maybe its just me, but I have been looking at both houses and photos of the spring system on houses. to me it looks like there is no way the spring can move the way they are attached.
  10. My son and I are thinking of building a wheel house out of an old 5th wheel trailer frame. It currently has two axles under it, I was going to take them out and replace with a single heavier one that would swivel up and down. Would use the front legs and add two 3000lb trailer jacks welded to the back to raise and lower. Trouble is I can only seem to find springs for the wheel with a 9/16 eyehole. I am worried that this will not be big enough to hold the weight when towing. The house would be approximately 18ft long and 6 1/2 wide. Are there springs with bigger eyes on them out there or will these hold. most of the weight should still be on the truck when towing.
  11. I have an older meyers plow that I am thinking needs the pump and or cylinders rebuilt. It moves slow when I first start and gets better the more I use it, which I just put off as being cold. However even after using it the angle arms do not hold in place when pushing snow and often takes a while for them to turn direction. any ideas? was thinking of getting new motor off the E site to see if that helps. thanks
  12. I have four trailers I want to clean and re-paint. was thinking of getting a smaller sand blaster to do the work. both northern and harbor freight have them for under a 100 dollars. anyone use these? also looking for suggestions on a non hazardous cleaning beads. thanks
  13. I have a 97 dakota that I put a meyers plow on, when I have the heater, radio and plow raising or turning the radio or heater will quite. am guessing that I either need to upgrade the alternator or replace the battery. anyone have similar problems?
  14. opsirc

    Rifle Scope

    am looking for a scope for my deer rifle,getting tire of the iron sites. am looking at either a Nikon, Bushnell, or Leupold, would like to stay around about $150. something within the area of 3x9x40 field of vision. Ideas??? thanks
  15. any one know if , if one of the pressure dials on a oxygen gauge for a torch set can be replaced because the needle is struck on the 30 psi spot or if there is something wrong with the total gauge? thanks
  16. been watching it for a couple of years now, not sure why. But my son was working for a company in Marshall, Michigan this past summer that was working on the embridge oil spill over there. they were using air boats to get around, most of which were hire from down south. His driver happen to be Elizabeth's brother. said he had some interesting stories to tell about her. bottom line was the producer have a tendency to add-live a little, imagine(sp) that.
  17. I will be in duluth tomorrow, give me a call 218.348.6547
  18. I have a couple of rods that do not have any way to attach the reels to them. I have tried electrial tape but it seems to have too much stretch to it. thought about shrink tubing but have not see any bigger than 1 inch. would need 1 1/4 - 1 1/2. what does everyone else use, there was disscussion on this before, but i could not find the thread. thanks
  19. first auger I own was a 10 with a 3hp, the beast was heavy and would not run at all, took that back and bought the SM lazer mag in a 9 inch. should I ever have to replace it would go with an 8, but simple because SM does not make the 9 any more.
  20. owned a lx3 for years and love it, the colors do blend a little, but as mentioned I have learned to read it. never had any problem with tuning out interference from other units and usally only need to turn the gain up a little to see even small jigs.
  21. i have used a kahle hook with a lot of success.
  22. I do not watch much news anymore, seems like all they want to report is the bad stuff and very little good. just my two cents. If I want info on ice or anything else I usally come to this site and get it from the fisherman who are out there fishing.
  23. we had this happen with a sun flower heater a few years back. we were set up in a series of insta(SP) tents put together. the heater flared up, the guy next to it jumped up and tried to claw his way thru the tent wall, was pretty funny. one of the other guys just reached over and turned it off. needless to say the one that jumped up left for the day, do not think he found it funny.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.