Guests - If You want access to member only forums on HSO. You will gain access only when you sign-in or Sign-Up on HotSpotOutdoors.

It's easy - LOOK UPPER right menu.

Sign in to follow this  
Followers 0
straydog

indy 500 clutch

6 posts in this topic

I bought a 95 indy 500, When I test drove it every thing was fine got it home and the wife and kids drove it around for about an hour and the clutch wont disengauge all the way if you hold the break it will kill the engine at an idle. Any one know what that might be?

Share this post


Link to post
Share on other sites

Take a look. Could be one of a couple things.

Your belt is wore thin and it rode up into the secondary too far and got stuck. Spread the halves by turning each in opposite directions and work the belt out. Or a thin belt and primary closed past a point where the pucks got hung up. Hopefully its the first case and all you need is a new belt.

Share this post


Link to post
Share on other sites

Quote:
was fine got it home and the wife and kids drove it around for about an hour

Up, like ST said, I would check the belt. Nothing burns out a belt like the wife ands kids grin

Share this post


Link to post
Share on other sites

it also could be the clips and springs my buddies did this last yr and had to replace them

Share this post


Link to post
Share on other sites

after doing some internet research I found that it has the wrong belt on it.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  
Followers 0