Guests - If You want access to member only forums on HSO. You will gain access only when you sign-in or Sign-Up on HotSpotOutdoors.

It's easy - LOOK UPPER right menu.

Sign in to follow this  
Followers 0
IFallsRon

Refrigerator recall

6 posts in this topic

I got a letter this week from Starcraft. There's a defect in Dometic refrigerators manufactured between June 1, 2003 and Sept. 30, 2006.

You can get information at 1-888-446-5157 or www.dometic.com/recall.

Share this post


Link to post
Share on other sites

Got mine yesterday.

Camper is in storage 100 miles away. Look's like it will have to wait till the spring.

Sifty

Share this post


Link to post
Share on other sites

I can't recall for sure, but I'm remembering "explosion" from the paperwork.

Share this post


Link to post
Share on other sites

Its a fire hazzard recall. All they do is put some additional sheet metalin the back of the refrig. and put in a gas shut off.

Share this post


Link to post
Share on other sites

ok, thats the one i thought with the fire hazard... i have done

at least a 100 of them. they should recall the cooling units if

they know there is a problem. the recall kit comes with some

sheet metal pieces, a high temp sensor and a high temp fuse plus

some wiring. they already know the cooling units are junk, why

not just replace them now instead of covering up the problem.

randy

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  
Followers 0



  • Posts

    •   No expert here either but I've talked to a couple.    Would your new, expanded slab be conducive to making the addition another zone or zones?  You could maybe run that expansion off different lines from the manifold above the slab so you don't have to route and pour over seams.   Definitely insulate below with GOOD insulation.  As mentioned, heat doesn't really rise the way we think it does; it moves to the cold and the earth will soak it up.   Heating your loop would be cheapest with a natural gas fired boiler, propane second.  Geothermal is expensive to put in so your payback on a new system is long.  Air source heat pumps are great until it gets really cold.  In the end, radiant in floor is the most efficient way to heat, but yes, it's slow to respond.  But if your toes are warm, you will be too.
    • I appreciate the response, I take nothing personally and didn't mean to be snippy in my reply. There are a lot of great comments on here and I will keep you posted on what I decide. Thanks again. 
    • Ice is quickly thinning on those northern lakes that still have ice with dangerous conditions on most lakes. The Wisconsin River is now open even in its northern stretches, but ice chucks can be seen melting along the river's edge. The lower Wisconsin River has finally dropped to near normal levels. Some walleye and brown trout are being caught on the Menominee River both trolling and angling from shore. Low water and cool water temperatures slowed the walleye run so far on the Oconto River. Anglers along the Wolf River have been starting to catch walleyes. A few sturgeon have been seen along the Wolf River, but warmer temperatures are needed for the sturgeon to start their annual spring spawning run. Walleye and sauger action on the Wisconsin River and Lake Wisconsin is slowly picking up.The steelhead season opened on the lower stretch of the Brule River last weekend and anglers reported good successPhoto Credit: DNRSpring steelhead fishing opened last Saturday for the lower stretch of the Brule River and there were lots of fishermen and fisherwomen on the river many who had a successful opener. .
    • I apologize if that came out wrong. The idea might very well be the best route to go. It's just that over the past 25 years or so I have seen many attempts to save a dollar that cost a buck and a half to do lol.    Here are my two cents. If you have a slab and you want to pour on top of it while keeping the same footprint that sounds pretty doable and could probably save some money if you don't have to change drain lines, run water, heat runs, electrical etc into the slab.   If you intend to tie into the existing slab and run zones of pex across the joint and have the new and old floors end up at the same elevation it still can be done. Some contractors will not want to mess with tying into and raising the elevation of the slabs and will prefer to start from scratch especially if you as the homeowner want them to warranty the finished product.  The critical thing would be to use enough rebar drilled into the old slab and have enough compaction and sufficient footings to make sure the slabs stay where they are without settling. That would make all kinds of problems with the pex.    Hopefully that response came across better.
    • It'll be interesting to see if the team plays a little harder in front of a different goalie. 
    • Hawg, I'm with you on this one !
    • Check and see if you have a video output on you device. You may be able to record to a digital device.
    • Just use plain old spray paint in a can. I've done it many many times and seems to stick really nice. Nothing special either I can't even tell you the brand because I have no clue. But as mentioned doing 2-3 light coats helps.
    • no expert here, but heat doesn't rise. heat radiates in the direction of least resistance (R value). warm air or water rises because it is less dense than colder air or water.  If you don't insulate you will be heating the ground under your cabin and the earth is a very large heat sink $$$. get some info from an expert in the radiant field as far as tube diameter, spacing, water temp, manifolds, length of runs, and so on. it varies on amount of windows (solar) ceiling height and room type (bed, bath, living area,  storage etc.). once you pour over the tubing you get to live with it. I did my own Home 15 years ago and got some good advise (wish I would have taken it all)
    • Sonar works from above, cameras need to be submerged. What am I missing here?
  • Our Sponsors