Guests - If You want access to member only forums on HSO. You will gain access only when you sign-in or Sign-Up on HotSpotOutdoors.

It's easy - LOOK UPPER right menu.

Sign in to follow this  
Followers 0
Canon Guy

Alaska cruise

11 posts in this topic

We did an Alaskan cruise last week and the weather was not what I had hoped for. Previous to the trip I had arranged a guide to take me to a bird sanctuary near Sitka to shoot Puffins and whatever else was out there but the high seas prevented that trip. Nice vacation though.

Juneau

375962996_WjaEA-L.jpg

Mendenhall Glacier

375963005_D6Uti-L.jpg

Hubbard Glacier

375962991_Ms9m2-L.jpg

375963001_AbHJ5-L.jpg

Share this post


Link to post
Share on other sites

Bruce, I empathize with you on uncooperative weather, but I am mighty jealous that you were able to photograph in Alaska. You've got some nice captures there!

Share this post


Link to post
Share on other sites

Those are fantastic Bruce. I am jealous as well. What a terrific set of memories you have there.

Share this post


Link to post
Share on other sites

I've got red X's, photo hosting must have issues.

Share this post


Link to post
Share on other sites

Thanks Steve and Mike,Alaska is awesome even in poor weather. Sorry Dan and Finnbay,I took them off the hostig site after I posted them,not knowing the repercussions. I'll try again.

376029533_pYDef-L.jpg

376029520_XsKcz-L.jpg

376029543_shkaE-L.jpg

376029553_rBMVq-L.jpg

376029531_CPHsq-L.jpg

Share this post


Link to post
Share on other sites

Now I see them, actually twice, first post and last. Very nice work Bruce.

Share this post


Link to post
Share on other sites

Now I see 'em, and am I glad! Beautiful work! I haven't been to Alaska since 1976, and I think another trip is going to have to be in store. You've got me drooling!

Share this post


Link to post
Share on other sites

Thanks guys,now I'm on my way to Ottertail to do some fishing for only the second time this summer.

Share this post


Link to post
Share on other sites

Great Pics!

My parents did a Alaskan Cruise about 2 months ago and it rained every single day, with 60-70 mph winds one day on the ocean...

It looks like you made the best of it though!

marine_man

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  
Followers 0



  • Posts

    • Preds make it to the finals.  I thought someone said they were the last team in and technically the 16 seed.   Who ever they face in the finals it will be a battle, hope the Sens make it.  But would be nice to see Cullen get a cup.
    • My hunt in WI this past weekend was tough as well.  I found tons of ramps, they grow everywhere in the area we hunted, but zero morels.  I saw a few pheasant backs, but did not pick them as they did not interest me.  
    • I finally just said screw it, so I picked a couple of guys that I thought would do good (Christie, and Rojas) and some over looked guys that have had a little success this year, and were from the area.  Would never had expected Alton Jones Jr, to go from 80 something place on day 1 to the top 12.  Glad he was on my team though
    • Added these for the fry pan to go with some turkey also.  
    • If you haven't planted your tomatoes yet......plant them laying down on their side. Pick off all the branches up to the top.Lay the plant in a trench and cover the stem up to the top. Put a soil pillow under the top. Just be careful not to break the stem (I have). Tomatoes are the only plant that will send out roots from the buried stem. You will wind up with a large root ball to feed the plant. This also puts the roots closer to the surface where the soil is warmer instead of deep where it is cool.
    • Another disaster. I tried making relatively safe picks, and bombed. I have gone from the top 60 after two events all the way down to just over the 90th percentile. I need to just go with my gut
    • that is what we were thinking too.
    • Live link.   http://www.dnr.state.mn.us/features/webcams/falconcam/index.html      


    • BEFORE BEGINNING

      Before you begin, make sure you have a good strong battery and make sure it's charged up. If you have a bad or weak battery, you may want to replace it because if it doesn't crank good and strong, you are likely to get a low, inaccurate reading. Make sure your engine is warmed up to operating temperature(if possible). About 10 minutes of riding should do.

      First, take out the spark plug and thread in the adapter for the compression tester. Make sure you have the correct size adapter for your particular ATV. Slide your kill switch to the "off" position. Some ATVs won't crank over with the kill switch in the "off" position, so if yours is like this, then you will need to either unhook your ignition coil or ground the end of the spark plug wire to a good ground. You can use a jumper wire with alligator clips on each end to ground it. Next, make sure the throttle is in the wide open position. You can either hold the throttle lever with your thumb or you may be able to tape it or use a zip tie to fasten it to your handlebars to hold it in the wide open position. If you don't have the throttle in the wide open position, you will probably get too low of a reading. Also, if you are testing a newly rebuilt engine, the engine needs to have been run for, at least, 30 or 40 minutes or you will probably get too low of a reading.

      NOTE: Before you begin with the actual test, make sure the threaded adapter is screwed in good and isn't leaking any air out around it.

      ACTUAL TESTING

      With the throttle in the wide open position, push the start button and crank the engine over until the hand on the gauge stops moving. Each time the engine turns over the hand should raise a little more until it reaches the maximum compression of the engine. When it stops, that is your compression reading. This usually takes no more than 10 seconds. Try to avoid cranking an engine for more than 10 seconds at a time as this is hard on the starter and the battery. Now, push the relief valve on your compression gauge and that will reset the hand back to zero. It's a good ideal to repeat the test a couple or three times to make sure you get an accurate reading. On kick start models, it will be the same procedure, but obviously you will be kicking it over instead of using a start button. Worn piston rings and cylinder walls will increase the number of strokes it takes to reach the maximum reading. If you're kicking, it could possibly take as many as 10-20 kicks to get the highest reading.

      THE READING

      You will need to check your repair manual for your particular model for the correct compression specifications. See note below. Usually, an engine will run OK if it has at least 100 PSI of compression. Most engines will have somewhere between 100-250 and some as high as 300 PSI, depending on the engine. Sometimes they will run with under 100 PSI, but usually not very well. If you get a low reading, you can do a "wet test" to try to help determine the problem.

      If your reading is too high, then you probably have carbon built up on your piston and combustion chamber.

      NOTE: You may get a low reading on some engines because some engines have a decompressor assembly built into the camshaft. Check the service manual for your quad to see whether or not your quad has a decompressor assembly built into the cam.

      WET TEST

      If you got a low reading, pour about 1-2 teaspoons of clean motor oil down into the cylinder through the spark plug hole and do the compression test again. If your reading increases, then your rings or cylinder walls are probably worn. If your reading doesn't increase, then it's probably your valves. You could have a bent valve, you may have leaky valve seats, or your valve clearance may not be adjusted properly. Also, low compression can be caused by a blown head gasket.

      CAUSES OF LOW COMPRESSION

      *Worn piston rings or worn or damaged cylinder walls
      *Leaking valves
      *Valve clearance not properly set
      *Blown head gasket

      CAUSE OF HIGH COMPRESSION (stock engines)

      *Carbon buildup in combustion chamber and on piston

      NOTE: Compression testing is a good way to keep track or "gauge" the wear in your engine. When you first get your ATV or when you rebuild the engine in your ATV, you can do a compression test and then later on, you can do them periodically. This will help you determine the wear in your engine each time you do a compression test and will guide you in knowing when your engine needs rebuilding.

      This is about all I can think of. I hope I didn't leave anything out and I hope this helps everyone with their compression tests.
    • As dumb as this sounds how is this done?
  • Our Sponsors