Guests - If You want access to member only forums on HSO. You will gain access only when you sign-in or Sign-Up on HotSpotOutdoors.

It's easy - LOOK UPPER right menu.

Sign in to follow this  
Followers 0
bassNspear

week 2........who would you start

18 posts in this topic

I have addai also and am thinking of starting C. Johnson since Ten. plays Cincy. Other big back is turner.

Share this post


Link to post
Share on other sites

How about pick 3 from this list:

Grant vs Det.

Barber vs. Philly

Portis vs

Parker vs. Clev.

Tunrevir~

Share this post


Link to post
Share on other sites

Not Addai - Vikes D

Not Jones Drew - Shares ball too much

Not Williams - Bears D

Fargus would probably be your best bet with 'guess lucky' coming in second

Share this post


Link to post
Share on other sites

How about pick 3 from this list:

Grant vs Det.

Barber vs. Philly

Portis vs

Parker vs. Clev.

Tunrevir~

Grant, Parker, and if healthy Barber.

Share this post


Link to post
Share on other sites

I'd go Fargas and Addai. Addai may see more passes out of the back field with Clark out and the secondary will have their hands full with Wayne, Harrison and Gonzalez. Good luck!

Tunrevir~

Share this post


Link to post
Share on other sites

Yep, gotta start Addai every week. Never leave one of the top players on the bench even if it APPEARS to be a tough matchup. They (vikes) haven't proven anything yet.

Fargas would be the other starter.

Share this post


Link to post
Share on other sites

Fargas

Jones Drew

Williams

Addi

who would you start for your two runningbacks this weekend?

Addai and Jones-Drew.

Next pick Fargas, then D. Williams I presume, not dreadlocked Ricky?

No rookie RBs on the wire last Monday BnS? Forte, C. Johnson, Felix Jones?

Good luck.

Share this post


Link to post
Share on other sites

No, there all gone. I play with alot of guys that know whats going on.

I started Addi and Fargas. Jones drew 3 mineman are out. We will see if it pays off.

Share this post


Link to post
Share on other sites

I have addai also and am thinking of starting C. Johnson since Ten. plays Cincy. Other big back is turner.

I was just on the Bengals fan forums on their HSOforum- rain and wind advisories in effect at gametime. Might be a great day for RBs.

Share this post


Link to post
Share on other sites

I think Addai does well today. Once Peyton opens up the passing game, he'll start hitting Addai quite a bit with little swing passes... I could see him busting open a few big runs too. Stick with your stud. Start Addai.

Share this post


Link to post
Share on other sites

I agree with Mike, BTW. I know the Vikes have the best run "D" in the NFL, but Grant had a couple great runs last week, one that was brought back by a flag.

Share this post


Link to post
Share on other sites

You didnt start Addai did you? Better hope he has a good second half.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  
Followers 0



  • Posts

    • LH...I repaired Shimano's for years, and this was a huge issue for the Stradics and the Sahara's, First, look at the bail and make sure that they are not out of alignment. I bet your problem is caused by one part (and it's the probable cause of both problems)..... To keep the bail from rotating on the cast (and snapping shut on you in mid-cast) there's a small friction ring inside the rotor. It looks like a heavy rubber band only it's made of heavy vinyl plastic. It's  actually called a "friction ring". When it goes bad it loosens up just enough to bind up your reel completely and the bail won't snap shut. Also check the round bail return spring with the smal 90* bend in it, that can pop out of the tiny hole (the "bent" end) and cause the bail to do literally nothing. If your bail actuator pin (your :latch") is bent/worn, that will do it, but unikey that it's worn down that much. Loosen up the bail center screws, and see if when they are loose the bail will return. If so, they may be bent/out of alignment. Takes some careful maneuvering to get them back to proper set. I love Shimao stuff, but they never did own up to this problem, as far as I know. Check those things first and let's go from there.

       
    • Look at the diagram, order the parts.   If it pops open or won't close I am still thinking the spring... Take pictures with phone or digital camera as you take it apart.  Helps to get it back together. 
    • Wrong guy there.  I don't fish in MN anymore, don't have a boat either. 
    • Clinton.     After Mn coughed up 66 million for 150 jobs in Cook, nobody from MN ought to be criticizing Indiana.  Looks like they got a heck of a deal.
    • who hasn't done something dumb like that.  I know I have!   good luck making it up to you Mother!!
    • *sigh* Kiss of death my friend............. kiss of death.   LOL
    • make / manufacturer: Eskimo
      model name / number: Mako Upgraded to an electric auger and selling my old one. Runs great and has been well taken care of. Starts on 2-3 pulls every time. I have the extension for it as well as a new set of blades that I bought but haven't needed to change yet. I also have a cabelas auger bag that it fits in.
    • the thing that trips the latch is worn or broken.    i think   will take apart and look if i set hook hard the bail rackets pops up and lets line out won't close some of time...have to do manually
  • Our Sponsors