Guests - If You want access to member only forums on HSO. You will gain access only when you sign-in or Sign-Up on HotSpotOutdoors.

It's easy - LOOK UPPER right menu.

Sign in to follow this  
Followers 0
smilee_54

18 horse evinrude

6 posts in this topic

hey I guys i have a 66 evinrude 18 horse. Water has gotten into the lower unit so I am going to replace all seals since I have the lower tore apart due to a worn clutch dog. I am tring to figure out how to get the drive shaft seal out. I don't want to pry the thing out thanks ahead of time

Share this post


Link to post
Share on other sites

Unless you have access to the seal puller, or a small slide hammer, you're gonna have to pry them out. It can easily be done this way, just be careful of that little lip.

Share this post


Link to post
Share on other sites

Hey, is that 'rude a fastwin? If so, I have one too. purrs like a kitten, but it binds when i try to shift it.

Share this post


Link to post
Share on other sites

yes it is a fastwin. binds when you shift hmm. Are you shifting it slow or fast? Make sure you have the idle down far enough so the rps aren't too high. What year do you have?

Share this post


Link to post
Share on other sites

when the engine is not running is when it binds.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  
Followers 0