Guests - If You want access to member only forums on HSO. You will gain access only when you sign-in or Sign-Up on HotSpotOutdoors.

It's easy - LOOK UPPER right menu.

Sign in to follow this  
Followers 0
Farley

electric trolling motor

2 posts in this topic

does anyone know where i could bring a old electric trolling motor to get fixed. I'm not sure what's wrong with it yet, but I'm guessing it's a wiring problem since it doesn't get power. I live in the Cokato area and I mostly fish Clearwater, so do any of you know anybody in that area where I could bring it?

Share this post


Link to post
Share on other sites

Bruce's Outboard Shop in Sauk Rapids has done me well in the past. His Phone # is 320-253-9273. Better get on it asap as I am sure he will be busy this time of yr. He is the only one I am aware of around here

------------------

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  
Followers 0



  • Posts

    • I've also had good luck spray painting PVC.  Biggest thing I found is to do lots of light coats, the PVC makes the paint want to run in a hurry.
    • I believe you can do this with the Lowrance HDS 9 and above.
    • I'll go with another loss in overtime.
    • Calling a win tonight, it's going to happen!
    •   You'll probably run into plenty of "experts" among the experts, too...   Floor heat is nice, but definitely not the best option if you're looking for the best efficiency, since it is a slow recovery system.  If you were looking for efficiency and lowest cost, I would suggest looking into a mini-split heat pump to complement the gas furnace if you have off-peak available.   (Disclaimer: Not an expert either, but I have stayed at a Holiday Inn Express a few times.)      
    •   Same here. I have 3 of them. Use them in the SUV, Boat, Snowmobile, and Dual Sport bike. They seem to work better on my sled in the winter with no issues at all over my old ifinder which would eat batteries in the cold. They are discontinued but you can still find them out there on the List or bay once in a while. I like them as they are a crossover and can be used on the road or with a lake map which is the main thing I use them for. Wish they would bring something like it back.
    • Ridiculous... but it would work.  Sorry to offend, guess I don't get quite so fired up about concrete.
    • Concrete. Way easier to plow. My parents have a gravel driveway WORST THING EVER! Impossible to snow blow because of all the rocks always wet and muddy. Sure it's cheaper but in the long it's not worth the cheaper price. 
    • I have used a Lowrance XOG (no longer available) on my boat and on my snowmobile for years now with no problems with cold or speed of tracking. I use a Lakemaster card for Minnesota lake for fishing, a Navionics card for coverage in Canada and LOW for winter and summer fishing, and a Red Pine snowmobile trail map for riding. Have ridden at 30 below without any problem with the touchscreen, it is hooked up to sled power, so it probably is getting some heat, and I put it inside my jacket when I get off. I recommend that you do a little research on the available chips for where you are going because different manufacturers use different chips. My use pretty much limits me to Garmin, and expect to pay couple to $300+ for chips for where I travel.
    • So are you saying what happened to me did not happen ? We not talking about a 4 inch concrete slab , it is a thin layer of gyp crete that covers the pex , it has the consistency of water when poured and sets up fast, it is self leveling and any movement in the pex shows up and cant be undone . Yes if it was fastened continuously it could not move but that would be ridiculous . As so this discussion !  
  • Our Sponsors